2. Systems Check

Question 1

Hydraulic Panel…Check

Answer 1

• Hydraulic Synoptic Page…..Select
• Fluid quantities/temperatures…Check
• Pump 3A pressure….Check
• Pump 3A Switch….OFF
• Pump 3B Switch….ON (Check 3A pump outlineis white)
• Pump 1B and 2B…..ON (Check that Hyd 1 and Hyd 2 Lo Press caution out)
• 1B, 2B, 3B……Auto
• 3A….ON
• EICAS page…Select

Question 2

Ice Detector….Test

Answer 2

-Check ICE caution

Question 3

Emer LTS Panel…..Test

Answer 3

• EMER Lts switch….OFF (EMER LTS OFF caution)
• EMER Lts…..ON (Check lights on and EMER LTS ON status message)
• EMER LTS swtich…ARM (Check lights are off, EMER LTS on status msg out)

Question 4

Glareshield

Answer 4

• Master Warning Caution…Press Out
• Baro knobs….Set
• Speed knob…Set
• Alt knob…Preselected altitude

Question 5

Anti-Skid switch….armed

Answer 5

Check that no A/SKID INBD/OUTBD cautions are on

Question 6

MLG overheat detection system….checked

Answer 6

• Select OVHT and HOLD (Check MLG BAY OVHT warning on, “Gear Bay OVHT” aural message)
• Select FAIL (Check MLG OVHT FAIL caution message on)

Question 7

Thrust Reverser Panel

Answer 7

-Select ARM (Chekck L/R Armed and no Unlock caution)

Question 8

Stall protection system…Check

Answer 8

• Stabalizer trim switch…Select to NOSe DN and hold until trim is 0 units
• Flight controls page…Select
• Pusher Switches…on
• SPS L/R switches…Test and Hold (Check stall fail caution)
• SPS test indicators verify (check that both test indicator needles sweep counter clockwise passed the red region and then clockwise back to the red region)
• Ignition A,B, Cont ON lights
• Ignition A,B advisory messages
• Within Yellow region stick shakers
• Within Red region pusher, stall lights, stall aural warning
• Pilots switch press,release,
• Copilot’s switch press (should pull), release
• check elevator against forward stop
• G Switch Press/Release
• SPS switches release (check Stall Fail caution out, pusher deactivated, shakers deactivated, Ignition out, stall lights out, aural warning stops).

Question 9

Pax and Mission Crew Oxygen….On/Check

Answer 9

Oxygen supply, pressure and quantity are sufficient. OXY LO PRESS caution message out.

Complete audio check by:

• Push OXY MIC switch/light
• Don headset
• Ensure overhead speakers are off
• Push Emergency button and check oxygen flow is heard over headset

Question 10

Tuning Inhibit switches…Press Out

Answer 10

604 RTU and FMS inhibit 605 CDU and MFD Tune Inhibit

Question 11

CVR

Answer 11

Test-Press and Hold Test

Question 12

Electrical Power Panel

Answer 12

Check-
BATT MASTER switch - ON
APU GEN switch - AS REQ
GEN 1 and 2 - OFF/RESET
Switch/lights - Check/All lights out

Question 13

Start/Ignition Panel

Answer 13

Check-
L and R ENG START switch/lights - OFF
IGNITION A, B, CONT switch/lights - OFF

Question 14

Fuel Panel

Answer 14

Check
BOOST Pump switch/lights - Check/INOP lights on
X/FLOW swtich/lights - Press Out/OFF
TAIL TANK TXFR/DUMP switch/lights - Press OUT/OFF
EICAS page - Check tank quantities and balance

Question 15

Air-Conditioning Panel

Answer 15

Check
CKPT mode selector - NORM
CABIN mode selector - NORM
RAM AIR switch/light - Check/pressed out
Temp Cntls - AS REQ

Question 16

Cabin Pressurization Panel

Answer 16

Check
EICAS page Check - diff 0, cab alt=field elevation, rate of climb 0
MAN ALT - Centered
MAN RATE - Full decrease
Press Cont switch/light - Pressed out (Man light out)
EMER Depress switch/light - Pressed out (On light out)
Auto pressure controller - Set field elev, baro, rate

Question 17

Bleed Air Panel

Answer 17

Check
14th Stage L/R - Pressed in, closed light out
14th Stage ISOL - Pressed out, open light out
10th Stage L/R - Pressed out, open light out

Question 18

Anti-Ice Panel

Answer 18

Check
Wing Switch - Off
L/R HEAT - Lights out
COWL switch/lights - Check pressed out
WSHLD/WIND and Probes switches

Question 19

Air Data/Altimeter

Answer 19

Set

Question 20

Side Panels

Answer 20

Check/Set
Audio Control Panel - As Req
STALL PROT PUSHER - ON

Question 21

EFIS

Answer 21

Check

Crosscheck ADIs and RMIs

Question 22

EICAS

Answer 22

Check

Question 23

GPS Clock (605)

Answer 23

Check/Set to correct local time

Question 24

GPWS Check

Answer 24

Complete

Question 25

FLAPS

Answer 25

Check

Question 26

Engine Vibration Test

Answer 26

Complete VIB switch Select to Test, Check the following; VIB icon displayed on N2 gauges or adjacent to N2 readout, FAN VIB readout of 3.5 +/- .1 mils of VIB icon displayed on N1 gauges in compressed display format.

Question 27

Aural Warning System Check

Answer 27

Complete | Select to 1 and release, Select to 2 and release. (reselection cancels the aural messages)

Question 28

Stall Protection System Check

Answer 28

``` Complete Stab Trim - Full Nose down Flight Controls Page - Select Pusher Switches - On SPS TEST L/R - Test and Hold -Ignition A/B and Cont ON lights come on -Ign A/B Green Advisory come on -Stick Shaker in Yellow -Pusher, Aural, and lights in red Pilot A/P disc switch - Pusher deactivated Pilot A/P disc switch - release Repeat with CP Flight Controls - Check Elevator full forward G-Switch - Same as autopilot ```

Question 29

TCAS Check

Answer 29

Complete

Question 30

Flight Control Trim Systems Check

Answer 30

Complete CH1/MACH TRIM Switch Lights - Press In (2 inop) clacker both sides in both directions CP Stab TRIM DISC - Press (STAB/MACH TRIM Caut) Repeat for CH2 Engage both Channels and Mach trim (no caut) Aileron and Rudder Check both directions