Ground Incident
Engine Fire/Failure/Severe Damage/Separation
at or above V1
As per I will/You Will
During a bleeds off take-off, if engine falure occurs, do not position engine BLEED AIR switches ON until reaching 1500 feet or until obstacle clearance height has been attained.
Engine Inoperative Cruise/Driftdown
PF - “Disengage Autothrottle”, “Set Max Continuous Thrust”.
PF - Adjust trim
PM - Disengage Autothrottle
PM - Select CON Thrust in FMC
PM - Manually set MCT
PF - Confirm MCT set
PF - Request ENG OUT and ECON on cruise page
PM - Set Altitude on MCP/ Set Airspeed on MCP
PF - Slow to ENGINE OUT TARGET airspeed then - LVL CHG
PM - All exterior lights - ON
PM - ATC Adivse
PF - Initiate Turn IF REQ’d
“Checklist Engine Failure”
Overweight Landing
Airspeed can be reduced by as much as 20 knots below normal normal maneuver speeds before extending to the next flap setting.
Cabin Altitude WARNING
In Flight - Perform Cabin Altitude Warning/Rapid Depressurization Drill
On Ground - This is “Takeoff Config” warning.
Rapid Depressurization and Emergency Descent
As per I will/You Will
In the event of an explosive decompression, go to EMERGENCY DESCENT.
Driftdown Escape Charts
It is possible that the driftdown at the optimum speed penetrtes the GRID MORA. Terrain clearance is still assured provided crews follow the depicted escape route and optimum driftdown profile.
Decompression/Driftdown Escape Charts
Use TERRAIN VSD to help with situational awareness
Traffic Avoidance
TA
PF/PM - Look for traffic using traffic display as guide. Call out any conflicting traffic.
PF - If traffic is sighted, maneuver if needed.
Maneuvers based solely on a TA may result in reduced separation and are not recommended.
Traffic Avoidance
RA - ALL PHASES (Not landing)
PF - Disengage AP and AT
PF - Smoothly Pitch and Thrust to follow RA Command
PF - Follow lateral path planned
PF/PM - Attempt to establish visual contact. Call out any conflicting traffic
PM - “AC XXX, TCAS RA”
Do not use the FD commands until clear of conflict
DO NOT follow a DESCEND RA issued below 1000’
Traffic Avoidance
RA - LANDING CONFIG
PF - Disengage AP and AT
PF - Maximum Thrust, Flaps 15
PF - Smoothly Pitch to follow RA Command
PF - Follow lateral path planned
PF - “Gear Up” @ PM “Positive Rate”
PF/PM - Attempt to establish visual contact. Call out any conflicting traffic
PM - “AC XXX, TCAS RA”
Do not use the FD commands until clear of conflict
DO NOT follow a DESCEND RA issued below 1000’
Upset Recovery - Nose HIGH
PF - Recognize and confirm
PF - Disengage AP/AT
PF - Nose-down Elevator
PF - Nose-down Stabilizer Trim as required
PF - Reduce Thrust
PF - Roll for nose down
Recover
PF - @ Horizon, roll wings level
PF - Airspeed & Thrust
PF - Pitch
Excessive use of trim or rudder not recommended
HGS Symbology - Bank angles > 55 degrees / Pitch attitude > +35/-20 degrees
Upset Recovery - Nose LOW
PF - Recognize and confirm
PF - Disengage AP/AT
PF - Recover from stall, if required
PF - Roll in shortest direction wings level (unload first)
Recover
PF - Apply nose up elevator
PF - Apply nose up trim
PF - Adjust thrust and drag
Excessive use of trim or rudder not recommended
HGS Symbology - Bank angles > 55 degrees / Pitch attitude > +35/-20 degrees
GPWS Caution
CAUTION TERRAIN / CAUTION OBSTACLE / AIRSPEED LOW / SINK RATE / TERRAIN/ DON’T SINK / TOO LOW FLAPS /TOO LOW GEAR / TOO LOW TERRAIN / GLIDESLOPE / BANK ANGLE
Correct the flight path, airplane configuration, or airspeed
If a terrain caution occurs when flying under daylight VMC, and positive visual verification is made that no obstacle or terrain hazard exists, the alert may be regarded as cautionary and the approach may be continued.
GPWS WARNING
PULL UP / OBSTACLE OBSTACLE PULL UP / TERRAIN TERRAIN PULL UP
PF - “FIREWALL”
PF - Disengage AP/AT
PF - Max Thrust (aggressive)
PF - Roll wings level & Pitch 20 degrees UP
PF - Retract speedbrakes
PM - Assure Maximum thrust & verify actions
PM - Monitor vertical speed and altitude
PF - Do NOT change gear or flap until clear of terrain
Terrain contact remains threat, rotate to pitch limit indicator or shaker. Do not use FD. If positive visual verification is made that no obstacle or terrain hazaed exists when flying under daylight VMC conditions PRIOR to a terrain or obstacle warning, the alert may be regarded as cautionary and the approach may be continued.
Over-Run Warning (ORW) Airborne
OVERRUN, GO-AROUND aural alert OR GO-AROUND annunciation on the PFD
Execute a go-around
Overrun Warning (ORW) On-Ground
MAX BRAKES, MAX REVERSE aural alert OR MAX REVERSE annunciation on the PFD
I Will/You Will from Rejected Takeoff
Start movement of the reverse thrust levers to reach the reverse idle detent before taxi speed. After engines are at reverse idle, move the reverse thrust levers to full down.
STALL
PF - “STALL”
Initiate Recovery
PF - Hold control column firmly
PF - Disengage AP/AT
PF - Apply nose down Elevator
PF - Apply nose down stabilizer trim as needed
Continue Recovery
PF - Roll wings level shortest direction
PF - Thrust as needed
PF - Retract the speedbrakes
PF - During liftoff if flaps are up - Call flaps 1
Complete Recovery
PF - Check airspeed and adjust thrust
PF - Establish Pitch
PF - Retract-engage automation
PM - Monitor altitude and airspeed
PM - Verify all actions have been completed, call out omissions
PM - Call out any trend toward terrain contact
DURING TAKEOFF - if flaps are up, call for flaps 1
Windshear Caution
MONITOR RADAR DISPLAY
Maneuver as required to avoid the windshear
Windshear WARNING
Predictive On-Ground
“WINDSHEAR AHEAD, WINDSHEAR AHEAD”
Prior to V1 - Reject
After V1 - perform the Windshear Escape Maneuver
If there is insufficien runway left to stop, after V1, initiate a normal rotation at least 2,000’ before the end of the runway, even if airspeed is low
Windshear WARNING
Predictive Airborne
(“GO-AROUND, WINDSHEAR AHEAD”)
Perform the Windshear Escape Maneuver
or
Perform a Normal Go-Around
Windshear WARNING
(“WINDSHEAR, WINDSHEAR, WINDSHEAR”)
<1500AGL = +/- 15kts OR +/-500fpm OR +/- 5 degrees pitch OR 1 dot from glideslope OR unusual thrust
MANUAL FLIGHT
PF - “WINDSHEAR TOGA”
PF - Disengage AP
PF - Push TOGA
PF - Max thrust (aggressive)
PF - Disengage AT
PF - Roll wings level & pitch to 15 degrees nose up
PF - Retract speedbrakes
PF - Follow FD guidance (if available)
AUTOMATIC FLIGHT
PF - “WINDSHEAR TOGA”
PF - Push TOGA
PF - Verify TOGA mode FMA
PF - Verify Thrust
PF - Regract speedbrakes
PF - Monitor
BOTH
Low Energy Go-Around
In descent + thrust at or near idle + airspeed decreasing + aircraft height is equal to or less than 50’
Wheels may touch, this is ok.
Go Around - One Engine Inoperative