What is the bell-buzzer code for police assistance?
9
What does the bell-buzzer code 1-2 mean?
Close Doors
What does the bell-buzzer code 1 mean?
Stop
What does the bell-buzzer code 2 mean?
Ready to Start
What does the bell-buzzer code 3 mean?
Set back
What does the bell-buzzer code 3-3 mean?
Guard required by driver, Driver/Guard to attend telephone
What does the bell-buzzer code 4 mean?
Slow Down
What does the bell-buzzer code 5 mean?
Driver Leaving the Train in Accordance with Rules
What does the bell-buzzer code 6 mean?
Draw forward
What does the bell-buzzer 2-2 mean?
Do Not Open Doors
What is the bell-buzzer code for checking the door interlock after a door test has been completed?
3-2-1
Off all the bell-buzzer codes discussed, which if any do not require to be repeated back by the driver/guard?
3-2-1 Only if the interlock is being tested
During darkness, which handsignal would be given to the driver to advise him to Stop?
A red handsignal held steady
If the bell/buzzer communication was inoperative how would you give the Driver the Ready to Start signal during daylight?
A Green Flag held steady or by reaching a clear verbal understanding with the Driver
What Handsignal would Platform Staff give you to indicate that doors are not obstructed during darkness?
A White light held steadily.
During daylight what handsignal would you receive from Station Staff to indicate that station work is complete and all the doors were closed on a Slam Door train?
One Arm Raised Above head
During poor visibility or darkness how would Station Staff indicate to you that station work was complete?
A White light held steady above the head.
What hand signal would Platform Staff give you to indicate that the doors are properly closed and nobody is trapped during daylight?
One Arm raised above the head.
What must you do if you become involved in any unusual incidents
Submit a report before the end of your shift
How would you assist the driver when the train required to be turned or reversed.
One bell once past the appropriate signal
What does the “Ready to Start” signal indicate to the Driver?
That Station Work is complete
