The transmission shifts hard, the input bearing is noisy and the unit has had repeated clutch failures. What would be the cause of this problem?
Clutch housing allignment
What will cause an automatic transmission retarder to have poor braking performance and produce excessive heat?
The torque convertor lock-up clutch is slipping.
Which of the following would cause the engine speed at converter stall to be higher than specification?
The stator was not held stationary during the stall.
What would cause vibration, a hard “clunk” over uneven ground, and the driveshaft to be out of phase?
Twisted driveshaft due to severe shockloads
What would cause one u-joint to wear out repeatedly with signs of brinelling?
Insufficient driveline angle
What would cause a hydraulically controlled automatic transmission to shift from first to second too soon, while all the other shift points are normal?
Spring tension at the 1-2 shift signal valve too low
How should throttle position changes affect shifting in a hydraulically controlled automatic transmission?
Full or heavy throttle operation should cause the transmission to downshift at higher speed
What would cause a high temperature reading on the input pinion of a rear axle after overhaul?
Excessive pinion bearing preload.
What would cause a heavy heel pattern on a hypoid gear set?
Backlash is excessive
What would cause the right side tandem housing to tip in toward the top of the grader frame?
Worn pivot bushings
Which procedure should be performed when replacing a clutch?
Check bell housing allignment before installing clutch assembly
During a convertor/transmission repair, how is a torque convertor checked for leakage?
Pressureize converter with specific air pressure
What is the final procedure when installing a torque converter on a transmission?
Engage pump impeller with the shaft
What should be done if a universal joint bearing cup fails to purge?
Release seal tension, then apply grease
Which procedure should be used to test a powershift transmission which has low driving force in 3rd forward and 3rd reverse?
Verify complaint, then pressure test the speed clutch assembly
To adjust bearing endplay on a transfer case, what steps would the technician follow?
Measure endplay with a dial indicator, calculate shim pack
What needs to be done to correct a ring and pinion gear pattern which has excessive flank contact?
Move pinion out
What is the final step when assembling a single-reduction carrier assembly?
Set the thrust screw to high spot of bevel gear
