Forcible Entry1

Question 1

Inward opening doors.
By placing the fork of the Halligan approximately ——— above or below the lock with the ——- side of the fork next to the door, slightly countered toward the floor or ceiling.
2A

Answer 1

6 inches
Bevel side

Question 2

Mortise lock, after pulling the cylinder, insert the —- end of the K tool into lock through the cylinder hole, holding K tool ——- to the ground and perpendicular to the door. With the bent end pointing to approximately. —— o’clock, move the bolt slide to the —- o’clock position, as if slide is found at the 7 o’clock position, move the slide to the 5 o’clock position.
4.2. 2

Answer 2

Bent end
Parallel
5 o’clock
7 o’clock

Question 3

Mortise lock.
If after the deadbolt is retracted 5 to 7, the latch is still in the lock position knob will not turn, continue rotating. The key tool until contact is made with spring loaded latch lever, which is usually found at. —— o’clock or
—- o’clock. Depress this latch to release the spring latch. 4.2. 4

Answer 3

9 o’clock
Or
3 o’clock
ACRO It’s always Spring time in L39
Slide Bolt 5 to 7
Spring loaded Latch 9 to 3

Question 4

There are two types of padlocks
Regular with shackles of —— inch or less and not hardened.

Heavy duty with shackle of more than —- inch and hardened.
5A

Answer 4

1/4 inch or less not hardened
MORE THAN 1/4 inch and hardened

Question 5

American lock series 2000.
Cut through the Lock about —- of the distance ——- from the keyway, cutting it into pieces.
6

Answer 5

2/3rds
Up from the Keyway

Question 6

By placing the ———- of the Halligan under the window at the center of the windowsill and applying —— pressure on the Halligan a single window and or window lock will be forced. 8.1.

Answer 6

Fork end
Downward pressure

Question 7

How do we attack a Window gate from which side? 8.1 a

Answer 7

Hinge side opposite the locking device using a Halligan.

Question 8

Multi lock doors easily recognizable by —— covering the lock. ——- bars, one in each direction, enter the door jam when the lock is engaged.
9.1

Answer 8

Large plate covering
Four bars 

Question 9

Multi lock doors.
Make sure ——- prior to forcing entry.
By sliding ——- or ——— under the door along the bottom, you’ll be able to tell if Lock is engaged or not. 9.1.

Answer 9

Multi Lock is engaged prior to forcing entry.
Sliding paper or cardboard

Question 10

Multi lock doors
To force the door, cut a —— ——- of the door on the doorknob side. This will enable you to unlock conventional locks as well. Make sure the cut large enough to get your arm through and back out, but small enough so that you DONT cut the bar. 9.1.

Answer 10

Cut a triangle in a lower quadrant

Question 11

What are the three types of security gates?
10.1

Answer 11

Manually
Mechanical
Electric

Question 12

If a delay is anticipated and heavy fire, condition exists, and application of water is of immediate necessity, the security gate may be cut using the saw.
A. ——- —— shaped opening, may be made rapidly, below the —— of the door and stream directed into the store.
10.2

Answer 12

Small triangle shaped
Center