HMMS

Question 1

What is a primary difference between the SAL and RF missiles?

Answer 1

SAL tracks laser energy (passive)
RF tracks reflected RF energy (active)

Question 2

When a M36 training missile is detected, all live missile on board the aircraft will display____ in the missile icon

Answer 2

NA

Question 3

The fuse contains the ARM/SAFE device that arms a missile when its launch acceleration exceeds approximately____

Answer 3

10 G’s

Question 4

The AGM-114Rs minimum arming distances is ____ meters

Answer 4

375 meters

Question 5

The AGM-114K2 arms approximately _____ meters from the launching aircraft

Answer 5

181 meters

Question 6

When the thrust of the missile exceeds____ to_____ pounds, the missile will launch from the rail

Answer 6

600 to 830 pounds

Question 7

The AGM-114R missile thrust duration approximately 2.5 to 3.5 second and reaching a maximum velocity of

Answer 7

435 m/s or (845 Kts)

Question 8

Which component of the M299 launcher contains a training missile emulator which replicates RF missile operation

Answer 8

Launcher electronic assembly(LEA)

Question 9

Which MPD page allows the air crew to electronically arm the M299 missile launcher

Answer 9

WPN UTIL

Question 10

What is the minimum altitude to launch a SAL missile

Answer 10

32 Ft

Question 11

What are the normal pylon articulation limits when the missiles or rockets are actioned

Answer 11

+4° to -15°

Question 12

A SAL missile that has not been coded will display an ___ inside the missile icon

Answer 12

L

Question 13

RF missile that has an over temperature condition will display___ in the missile icon

Answer 13

OT

Question 14

A Hangfire will display____ in the missile icon and the message HANGFIRE will be displayed in the weapon status section of the high action display for six seconds

Answer 14

MH

Question 15

RF missile icons have a_____ instead of a straight line at the seeker

Answer 15

V

Question 16

The SAL missile LOBL Constraints symbology +/- ____ degrees and is being driven by the_____ _____ in the crewmembers display

Answer 16

+/-20 / missile seeker

Question 17

To prevent video washout by the missile exhaust aircraft should be oriented ____ to ____ towards the side from which the missile will be launched

Answer 17

3° to 5°

Question 18

The ALT channel selection is only available after a_____ channel has been selected

Answer 18

Priority

Question 19

The missile quantity defaults to____ for both channels if sufficient missiles are available of the selected warhead

Answer 19

3

Question 20

The____ ____ button is used to maintain AGM-114R missile in a LOAL flight trajectory

Answer 20

LOBL INHIBIT (L5)

Question 21

What is the tri-service PRF code range

Answer 21

1111-1788 (No 9’s or 0’s)

Question 22

The AGM-114R missile main warhead default at power up for an armor with a fuse selection of

Answer 22

SQ (Discrete code of 1755)

Question 23

What negative factor during target illumination will cause a laser energy to be mass within the target

Answer 23

Entrapment

Question 24

What are the 3 LOAL trajectory modes in which the AGM-114R missile can be employed

Answer 24

DIR, FLAT, and LOFT

Question 25

When the TADS LOS and the missile seeker LOS differ by more than____ degrees a BACKSCATTER message will be displayed in the weapons inhibit section of the HAD

Answer 25

2°

Question 26

Which LOAL trajectory should be used to engage a bunker when firing an AGM-114R missile

Answer 26

FLAT

Question 27

When laser designating a 5000 m target for the AGM-114R missile, that lasts____ of the seconds of the TOF is required to be on the target

Answer 27

6 Secs(terminal guidance)

Question 28

The AGM-114R LOFT Constraints box is being driven in the crewmembers displayed by the____or____

Answer 28

Stored coordinate data(R6) or SEL LOS

Question 29

The remote designator should not be displaced more than____ degrees in aid from the launch aircraft to target line

Answer 29

60°

Question 30

Maximum autonomous designation range is limited by the

Answer 30

TADS ability to maintain the total laser spot on the target

Question 31

During a remote designation employing the AGM-114K the remote designator must be positioned outside of the +/-___ degrees safety fan either side of the gunner shot line

Answer 31

+/- 43°

Question 32

5 km engagement, the maximum separation between targets should not exceeded____ meters, with an____ second separation between missile launches

Answer 32

100 meters/ 8seconds

Question 33

The ripple mode, after the primary channel missile is launched the alternate channel missile may be launched after____ second separation

Answer 33

1.5 sec

Question 34

For an autonomous engagement, the aircraft should be oriented_____to_____to the side from which the missile will be launched

Answer 34

3 to 5°

Question 35

The AGM-114L missile MODE selections are ____ in each crew station

Answer 35

Common

Question 36

In the AUTO power mode missiles are powered up at_____ minute interval

Answer 36

10

Question 37

2nd TARGET INHIBIT selection is used for engagements against_____ target only

Answer 37

Stationary

Question 38

The RF missiles can overheat(OT) if it’s radiating(tracking) at target for more than______ minutes

Answer 38

3 min

Question 39

With 6 AGM-114L missiles loaded the AUTO power mode selection will power up____ RF missiles

Answer 39

2

Question 40

The AGM-114L allowable constraints is +/- ___ degrees when tracking the NTS target when the range is less than 1 km

Answer 40

5°

Question 41

Name the three RF missile modes

Answer 41

STBY, Pre-Launch, and Post-Launch

Question 42

Transfer alignment occurs in the_____ missile mode

Answer 42

STBY

Question 43

In the pre-launch mode, what are the three methods of target handover to the RF missile

Answer 43

FCR, TADS, and IDM (RFHO)

Question 44

Doppler beam sharpening(DBS) uses a curved trajectory to induce a relative motion for stationary targets(STI) hands are probability of detection and tracking between what ranges

Answer 44

2500-8000 meters

Question 45

At a range of ____ to ____ meters, targets are too close for a LOAL engagement and a”NO ACQUIRE” message will be displayed

Answer 45

500-1000 meters

Question 46

The three RF missile acquisition modes are_____,_____,and_____

Answer 46

Terminal track acquisition, pre-terminal track acquisition, and moving target acquisition

Question 47

What inhibits can be overridden , and how is this accomplished

Answer 47

Performance, 2nd detent

Question 48

Is the message” BACK SCATTER” a safety or performance inhibit

Answer 48

SAFETY INHIBIT

Question 49

What does the message “ALT LAUNCH” mean

Answer 49

A rocket launch is in progress. Missiles are inhibited from firing for two seconds

Question 50

What is the RF missile radiation hazard area to be avoided

Answer 50

1 meter 45°

Question 51

When in training mode, all tactical missiles will display____ inside the missile icon

Answer 51

NA

Question 52

The TME allows for thermal management of the missiles by allowing for cumulative time on of____ minutes

Answer 52

30 minutes

Question 53

With the TRAIN mode selected in a weapon system is action the weapons inhibit field will display

Answer 53

Training

Question 54

With the TRAIN mode selected and the missile system is actioned, the missile constraints box will display a _____ centered in the box

Answer 54

T