1
Q
- Most of the fumes from finishing materials are ____ (heavier or lighter) than air.
A
Heavier
2
Q
- All filter units and water traps in the shop air system should be drained ____ (what interval)
A
Daily
3
Q
- Powder coating, or “dry painting” is usually reserved for parts such as ____ ____ and
____ ____ ____
A
Engine Mounts
Landing Gear Struts
4
Q
- The two basic spray gun types use either ____ feed or ____ feed
A
Suction
Pressure
5
Q
- Filter-type masks when worn by spray painters _____ (will or will not) filter out the paint fumes.
A
Will not
6
Q
- Paint mixing agitators should be driven by an ____ drill motor, never with an ____ drill motor.
A
Air
Electric
7
Q
- A correctly adjusted spray gun should produce a uniform fan-shaped spray, with the fan ____ (parallel or perpendicular) to the wing ports.
A
Perpendicular
8
Q
- An excessive overspray may be caused by too ____ (much or little) atomizing air pressure
A
Much
9
Q
- Match the spray pattern with the number that identifies the cause of the distortion,
___ Material 100 thick for the amount of atomizing air
___ Plugged-up wing part hole on one side
___ Normal spray pattern.
___ Too much air through the wing port holes for the amount of material that is being sprayed.
___ Material buildup in the air cap.
A
2
5
1
3
4
10
Q
- “When painting an airplane, you should paint the corners and edges first, then the flat surfaces.” This statement is ___ (true or false).
A
True
11
Q
- Each pass made by a paint spray gun should overlap the previous pass by about ___ (what fraction) of their width
A
⅓ to ⅔
12
Q
- When an airplane is sprayed, the painting should be done so the overspray falls ___ (ahead of or behind) the area being painted.
A
Ahead of
13
Q
- Immediately after use, all spray equipment should be cleaned with ____
A
Thinner
14
Q
- An extremely thin ___ masking tape provides the sharpest lines for trim colors.
A
Polypropylene
15
Q
- The location and size of registration numbers required on an aircraft are specified in Federal Aviation Regulations Part ___
A
45
16
Q
- The Roman letter ____ preceding the registration numbers must be placed on all civil aircraft registered in the United States of America.
A
N
17
Q
- How much length would be required to lay out the numbers N469AR, if the numbers are 12 inches high? ____ inches.
A
58 inches
18
Q
- A ball-point pen is a ____ (good or bad) tool to use to mark the surface of an aircraft when laying out the registration numbers.
A
Bad
19
Q
- Decals are applied by soaking them in clean warm ___ until the clear portion slides easily from the backing.
A
Water
20
Q
- Dried overspray on the paint shop floor should be removed by ___ (wet or dry) sweeping it.
A
Wet
(Airframes)Paints and Finishes
flashcards
Decks in class (4)
# Cards
