Memory Items

Question 1

Aborted engine start

Answer 1

1. Engine start lever (affected engine)……….CUTOFF

Question 2

Air speed Unreliable

Answer 2

1. Autopilot (if engaged)…………………..Disengage
2. Auto throttle (if engaged)……………..Disengage
3. F/D switches (both)……………………..OFF
4. Set the following gear up pitch attitude thrust:
   Flaps extended…………….10° and 80% N1
   Flaps up………………………4° and 75% N1

Question 3

APU Fire

Answer 3

1. APU fire switch……….confirm………..Pull, rotate to the stop, and hold for 1 second.
2. APU switch……………………………….OFF

Question 4

Cabin altitude warning or Rapid depressurisation

Answer 4

1. Don oxygen mask and set regulator to 100%
2. Establish crew communications
3. Pressurisation mode selector……………….MAN
4. Outflow VALVE switch……………….HOLD in CLOSE until the outflow VALVE indication shows fully closed
5. If cabin altitude is uncontrollable:
   Passenger signs…………………….ON
   PASS OXYGEN switch……………ON
   Complete emergency decent checklist memory items

Question 5

Elevator tab limit cycle oscillation

Answer 5

1. Airspeed……………………..reduce to 270 KIAS or until the vibration ceases, whichever is lower
2. Do not use speedbrakes or change the aircraft configuration to reduce speed

Question 6

Emergency decent

Answer 6

1. Announce the emergency decent. The pilot flying will advise the cabin crew, on the PA system, of impending rapid decent. The pilot monitoring will advise ATC and obtain the area altimeter setting.
2. Passenger signs …………………………..ON
3. Without delay, decent to lowest safe altitude or 10,000 feet, whichever is higher
4. ENGINE START switches (both)………CONT
5. Thrust levers (both)………………. reduce thrust to minimum or as needed for anti-ice
6. Speedbrake………………………… FLIGHT DETENT
7. Set target speed or Mmo/Vmo - caution, if structural integrity is in doubt, limit speed as much as possible and avoid high manoeuvring loads

Question 7

Engine fire
or
Engine severe damage or separation

Answer 7

1. Auto throttle (if engaged)…………… Disengage
2. Thrust lever (affected engine)……..confirm……..close
3. Engine start lever (affected engine)………. confirm………CUTOFF
4. Engine fire switch (affected engine)……… confirm……..PULL
   To manually unlock the engine fire switch, press the override and pull
5. If the engine fire switch or ENG OVERHEAT light is illuminated:
   Engine fire switch……. Rotate to the stop and hold for 1 second
   If after 30 seconds the engine fire switch or ENG OVERHEAT light stays illuminated:
   Engine fire switch……….. Rotate to the other stop and hold for 1 second

Question 8

Engine limit
or
Surge
or
Stall

Answer 8

1. Auto throttle (if engaged) ……………..Disengage
2. Thrust lever (affected engine)……… confirm…….retard until engine indications stay within limits or thrust lever is closed

Question 9

Engine overheat

Answer 9

1. Auto throttle (if engaged)…………….Disengage
2. Thrust lever (affected engine)………confirm……. close
3. If the ENG OVERHEAT light stays illuminated:
   »> go to ENGINE FIRE or ENGINE SEV DAMAGE or SEPARATION checklist and memory items

Question 10

Landing configuration

Answer 10

1. Assure correct airplane landing configuration

Question 11

Loss of thrust on both engines

Answer 11

1. ENGINE START switches (both)…………..FLT
2. Engine start levers (both)………………..CUTOFF
3. When EGT decreases:
   Engine start levers (both)…………. IDLE DETENT
4. If EGT reaches 950° or there is no increase in EGT within 30 seconds:
   Engine start lever (affected engine)……… confirm……CUTOFF, then IDLE detent
   If EGT again reaches 950° or there is no increase in EGT within 30 seconds, repeat as needed.

Question 12

Runaway Stabilizer

Answer 12

1. Control column……………………… Hold firmly
2. Autopilot (if engaged)……………. Disengage
   Do not re-engage the autopilot
   Control airplane pitch attitude manually with control column and main electric trim as needed.
3. Autothrottle (if engaged)………… Disengage
   Do not re-engage the autothrottle
4. If the runaway stops after the autopilot is disengaged:
   “Checklist complete”
5. If the runaway continues after the autopilot is disengaged:
   STAB TRIM CUTOUT switches (both)……….. CUTOUT
   If the runaway continues:
   Stabilizer trim wheel………….. Grasp and hold

Question 13

Takeoff Configuration

Answer 13

1. Assure correct airplane takeoff configuration

Question 14

Warning horn (Intermittent)
or
Warning light - cabin altitude or takeoff configuration

Answer 14

1. If the intermittent warning horn sounds or a CABIN ALTITUDE light (if installed and operative) illuminated in flight at an airplane flight altitude above 10,000 feet MSL:
   Don the oxygen mask and set the regulators to 100%
   Establish crew communication
   »> go to CABIN ALTITUDE WARNING or Rapid Depressurization checklist and memory items
2. If the intermittent warning horn sounds or a TAKEOFF CONFIG light (if installed and operative) illuminates on the ground when advancing the thrust levers to takeoff thrust:
   Assure correct airplane takeoff configuration