Normal Procedures NWCs

Question 1

If the AC will not accept ground power what can you do?

Answer 1

Cycle battery switch off then on

Question 2

For solo flight what should you do with the rear STBY ADI

Answer 2

Cage and lock

Question 3

Where should the cabin vents be directed during interior inspection?

Answer 3

So that moisture is not blown on the right console

Question 4

Which engine should be started first with not ext pwr?

Answer 4

Right

Question 5

Before engine start what should the EED FF read?

Answer 5

No higher than 200, may indicate EED/fuel transmitter failure

Question 6

Should F PRESS be illuminated prior to start?

Answer 6

It may be out due to residual pressure in the system

Question 7

Do not advance throttle if ___

Answer 7

No positive (>0) oil Px

Question 8

If ignition does not occur before ____ reset throttle to off

Answer 8

360 pph

Question 9

If EGT does not rise within ____ of FF then abort

Answer 9

12s

Question 10

After any aborted start ____ and wait ____

Answer 10

Maintain airflow, 2 mins

Question 11

Do not operate the seat raising actuator for more than ____ in ____

Answer 11

1 minute, 8 minute period

Question 12

How much helmet clearance should
You have from the canopy?

Answer 12

Fist FCP, Open Palm RCP

Question 13

What will corrupt DTC?

Answer 13

MDP power up with WOW out of norm

Question 14

Do not load ICAO data if

Answer 14

WAIT displayed on HUD

Question 15

If RPM does not reach Gen cut in speed before termination of the cycle then….

Answer 15

Push the engine start button to ensure electrical power is available

Question 16

If unsafe gear indication (stall warning, loss of AOA symbol, break-X) occur during engine start….

Answer 16

Do not touch the gear lever - shut down ASAP and have the gear pins installed

Question 17

What may occur with pitot heat operation greater than 30s?

Answer 17

YSAS disengage, ADC PFL (All three indexer lights) TAS not available

Question 18

Ensure what whilst checking TO trim

Answer 18

That the stuck physically moves to noted TO position

Question 19

Artificial feel assembly may cause what

Answer 19

Aileron and rudder to remain displaced with no warning to crew

Question 20

For night or high humidity, set cabin ECS to what

Answer 20

100% auto with canopy closed to preheat instruments. Can then be set to something comfortable in pre take off

Question 21

HUD may blank following Gen crossover check …

Answer 21

Recycling FCP UFCP power switch

Question 22

If brake drag is encountered/suspected…

Answer 22

Abort AC

Question 23

NW tyres are severely damaged with max deflection turns above ___

Answer 23

10 knots

Question 24

Taxi with canopies

Answer 24

Both open or both closed and pressurised

Question 25

Always ___ before opening canopy

Answer 25

RAM DUMP and check cockpit pressure

Question 26

Wake turbulence

Answer 26

2 mins for large AC, 4 for heavy aircraft, may be reduced if Xwind exceeds 5 knots

Question 27

Abort TO if AB fails to light within …

Answer 27

5s

Question 28

Low altitude compressor stalls are most likely

Answer 28

A few seconds after selecting MIL/MAX but immediately before the engines reach MIL/MAX

Question 29

What should be checked after gear is lowered from RCP?

Answer 29

FCP gear physically checked down

Question 30

Operate engines at ___ for ___ prior to shutdown

Answer 30

70% RPM or below, 1 minute

Question 31

Allow ___ for landing taxi light retraction / ram dump door / EGI shutdown prior to engine shutdown

Answer 31

10s

Question 32

EED may display FF of ____ after shutdown

Answer 32

200