Test 2

Question 1

What action does a signal person intend the operator to perform if he extends his arm at shoulders height makes a fist with his hand and sticks his thumb up

Answer 1

Boom up

Question 2

Within what percentage of level does it telescopic boom crane have to be for the gross ratings in the low charge remain valid

Answer 2

1%

Question 3

The load line of the crane you’re operating comes into contact with an energize powerline there’s no sign of any other danger such as fire in such a situation you should

Answer 3

Stay in the cabin to the lines are D energized

Question 4

You’re setting up your crane in a confined area and you cannot fully extend your fourth out rigger your crane does not have a load chart for intermediate extension working. In such a situation you should use the capacities in the:

Answer 4

On rubber load chart

Question 5

According to B 30.5 Mobile crane standard, how many randomly distributed broken wires in rotation resistant rope is cause for replacement of the rope

Answer 5

Two broken wires in six rock diameters

Question 6

Unless the manufacturer states otherwise the net capacity of a crane picking on the main boom is the capacity listed in the load chart;

Answer 6

Minus the weight of the rigging and all attachments

Question 7

Unless the operator takes account of boom deflection when lifted off the ground a properly rigged load may-

Answer 7

Swing out away from the crane

Question 8

Which is the most common cause of death to crane operators

Answer 8

Crane turn over

Question 9

When preparing to set up a mobile crane for operation which one of the following steps is not needed to be done by the operator

Answer 9

Check lunchroom location

Question 10

Before making a lift on outriggers, and operator should always:

Answer 10

Extend the out rigors completely and be sure the tires are clear of the ground and a stabilizer pads are firm on the ground

Question 11

Unless the manufacturer states otherwise truck cranes generally have no lifting capacity over which area

Answer 11

The front

Question 12

Working radius is defined as the distance from the_

Answer 12

Center of rotation of the crane to the center of gravity of the load

Question 13

If a bold line is shown on a load chart the capacities below the line_

Answer 13

Are based on stability of the crane

Question 14

Rough terrain crane capacities are generally greater over the

Answer 14

Front

Question 15

According to federal requirements, under what conditions is it OK for a person to ride the headache ball

Answer 15

It is never OK

Question 16

On duty cycle operations such as skipping concrete, most manufacturers require a crane’s load shark capacity to be reduced by

Answer 16

20%

Question 17

Boom length is measured from the

Answer 17

Boom hinge pins to the center of the boom tips Sheave

Question 18

Using the preferred method of Installing wire rope from a real onto a hoist drum, the rope runs from the

Answer 18

Top of the real to the top of the drum

Question 19

Truck crane capacities are usually greater over the

Answer 19

Rear

Question 20

A truck crane is set up on outriggers. The part of the world shark governed by stability is based on what percentage

Answer 20

85%

Question 21

When making a deduction for Stowe gym or extension, what type of deduction would you use

Answer 21

Deduction weight

Question 22

What is the minimum clearance distance one working around powerlines of 600 KV

Answer 22

35 feet

Question 23

Prior to moving a crane on to the job site the operator shit first determine the condition of the

Answer 23

Access road

Question 24

OSHA permits hoisting of personnel when

Answer 24

There is no less hazardous or practical way

Question 25

How often is it required to perform an inspection on swings were ringing there to be used

Answer 25

Before each use

Question 26

When lifting personnel, the total weight of the loaded personnel platform was not exceed what percentage of the rated capacity of the crane

Answer 26

50%

Question 27

Side loading of a crane’s boom is permitted

Answer 27

Only with freely suspended loads

Question 28

If the operator makes two audible signals when moving a crane he is intending to

Answer 28

Go ahead

Question 29

If a crane’s load mom indicator malfunctions the operator should

Answer 29

Cease crane operations and report the condition to the supervisor

Question 30

Blocking or cribbing may be placed under outrigger beams

Answer 30

Never

Question 31

According to OSHA 1926.1422, hand signal charts must be posted

Answer 31

On the lift equipment or vicinity of hoisting operations

Question 32

What effect does the proper use of mats, blocking, or cribbing have on the suitability of the supporting surface

Answer 32

Distribute the weight and lessons load on supporting surface

Question 33

According to OSHA 1926 subpart CC, when is a qualified rigger required

Answer 33

When employees are in the fall zone

Question 34

Walking placed under the Outrigger pads should be capable of handling

Answer 34

100% of the crane weight and 100% of the load

Question 35

Materials placed under the overhead energized powerlines should

Answer 35

Be handled only if minimum clearance is can be maintained

Question 36

When working at ground level nearest seller wall, the cranes Outrigger pads or tracks should be placed

Answer 36

At least as far back as the depth of the wall below ground

Question 37

When setting up a crane on out Riggers, the wheels of the crane should

Answer 37

We just high enough off the ground to relieve the tires of crane wait

Question 38

What information Hass to be labeled on the hook, lifting device, or assemblies

Answer 38

Rated capacity and weight

Question 39

Rotation resistant rope can be used with a swivel:

Answer 39

If the rope manufacturer approves

Question 40

I’m picking carry operations, you should:

Answer 40

Keep the boom as short as possible and the load as close to the ground as possible

Question 41

In reference to safety devices the letters LMI stand for what

Answer 41

Load moment indicator

Question 42

When preparing to hoist a light load, the hook should be position:

Answer 42

Directly above the load center of gravity

Question 43

When working around powerlines that are 700 KV, what is the minimum clearance according to table a required for any part of the crane and it’s a load

Answer 43

35 feet

Question 44

You plan to pick a load and you were told it weighs 36,500 pounds. Line pole on the crane you were operating is 9000 pounds. How many parts of line will you need

Answer 44

Five parts

Question 45

If a gym as directed, but not being used to lift the load, you should make a deduction from the gross capacities listed in the load chart based on:

Answer 45

The effective weight of the jib

Question 46

When the boom length of the crane falls between the links listed in the load chart, you should use the capacity listed for:

Answer 46

The next longest or the next shortest boom like which ever is the lowest capacity

Question 47

When traveling a crane under energized power lines of 40 KV, no part of the crane may come within what distance of the line

Answer 47

6 feet

Question 48

In order to control the drift of the load what was the operator do

Answer 48

Keep the boom tip over the load

Question 49

As you boom down, the leverage of the load on the crane will:

Answer 49

Increase

Question 50

If leading a crane unattended for an extended period of time how should it be left

Answer 50

The boom retracted and stowed or set at 0°

Question 51

What is the best type of taglines to be used near powerlines

Answer 51

Poly propylene rope

Question 52

What is the maximum wind speed allowed one hoisting personnel

Answer 52

20 mph

Question 53

Timber mats work best when they are

Answer 53

Bolted together

Question 54

As jib offset is increased

Answer 54

The really capacity goes down

Question 55

Boom angle is measured from

Answer 55

Horizontal to boom

Question 56

Barricades are erected to

Answer 56

Keep unauthorized personnel out

Question 57

What percentage grader is a sling from vertical to basket

Answer 57

100%

Question 58

The adverse effects of wind on a boom is more on

Answer 58

The side of the boom

Question 59

When a crane or his load comes in contact with the powerline, and the operator hast to leave the crane he should

Answer 59

Leave the crane without contact of the crane or the ground at the same time

Question 60

On a carry deck crane, which of these may be removed as per the manufacture

Answer 60

The extension

Question 61

The load shall not be attached by which of the following methods

Answer 61

Double wrapping the hoist a line around the load

Question 62

The term stowed boom extension means

Answer 62

The extension is pinned to the base section of the boom

Question 63

The term stored boom extension means

Answer 63

The extension is laying in the yard

Question 64

The term tipping axis means the same as the

Answer 64

Fulcrum point

Question 65

The tipping access of a crane is defined as

Answer 65

The point or line about which a crane tips

Question 66

The percentage of stability for commercial mounted boom trucks on stabilizers is

Answer 66

85%

Question 67

As the boom is lowered

Answer 67

The rated capacity goes down

Question 68

As Jim offset is increased

Answer 68

The radius will increase

Question 69

The effective way of any erected extension or jib is _______than actual weight

Answer 69

Higher

Question 70

The effective weights of a stowed extension or jib is_______then actual weight

Answer 70

Lower

Question 71

As per OSHA, when using hook blocks are overhaul balls with Personal platforms they must

Answer 71

Have a lockable type safety latch

Question 72

Backwards stability on a boom truck could be a problem on the crane is working

Answer 72

Over the side with a minimum radius

Question 73

The effective weight of a stored extension or jib______than actual weight

Answer 73

Will not affect the net capacity of the crane

Question 74

If the boom is designed to be telescoped out equally, and is not, what is most likely to fail

Answer 74

Longest boom section

Question 75

How often according to B30.5 standards are you required renew your physical exam

Answer 75

Three years

Question 76

When using a single leg sling to pick a load, and you change how it is rigged from the vertical hitch to a choker hitch, what is the percentage of sling reduction

Answer 76

25%

Question 77

When using standard voice signals, what is the first command be given

Answer 77

Function and direction

Question 78

With a loaded boom, what will most likely be the result of the load contacts the boom but a boom contacts the edge of the building

Answer 78

Boom collapse or damage

Question 79

What is considered working over the front of a truck mount a crane, when working from the center line of the crane

Answer 79

Manufacturer specifications

Question 80

Delay length of a wire rope is defined as the

Answer 80

Distance it takes for one strand to make a complete

Question 81

It is important to inspect rotation resistant wire rope more frequently

Answer 81

Internal damage will occur more frequently

Question 82

According to the OSHA 1926.1413, what is the maximum diameter reduction of wire rope for it to be removed from service

Answer 82

5%

Question 83

Load indicating mechanisms, overload warning systems, and other automatic safety devices have improved Cran safety, but are not intended to replace:

Answer 83

The skill and judgment of a safe operator

Question 84

When is it acceptable to not use a safety latch on the load hook

Answer 84

When you can show to use is impractical

Question 85

While interpreting the load chart on your crane, you find the cranes gross capacity is higher than the capacity of the hoist in this situation you should

Answer 85

Use hoist capacity minus all deductions

Question 86

While using a tool leg bridal if working with a 30° horizontal sling and go as opposed to a 60° horizontal sling angle:

Answer 86

The tension is increased

Question 87

If determining boom tip elevation is necessary the best way to determine elevation is to:

Answer 87

Use the range diagram

Question 88

If the anti two block device On the crane you are running quits working, what would be your best option for continued use of the crane

Answer 88

Mark the hoist cable for Operator to see he won’t 2 block

Question 89

If the horn on the crane you’re running quits working what should you do

Answer 89

Stop crying until horns repaired or replaced

Question 90

When using preformed IWRC wire rope and connecting wedge socket directly to the hook and ball assembly, what could the effect be

Answer 90

Rotation of the load

Question 91

Sideloading a crane, the most common effect would be

Answer 91

Swing gear failure

Question 92

If the powerlines are D energized who can verify this

Answer 92

Line owner

Question 93

If the length indicator on the crane you were running quits working, what would be your best option for continued use of the crane

Answer 93

Paint or mark the boom with the length

Question 94

What does D/d Ratio referred to in ready

Answer 94

Diameter of the load divided by the diameter of the sling