Flows

Question 1

Before start FO flow

Answer 1

1. ) Pressurization (set landing field elevation)

2. ) Altimeters (set on your side, and perhaps the ISI)

Question 2

Push/start FO flow

Answer 2

1. ) V-speeds (set v1, vr, v2, and vt. May be done by captain)
2. ) Fuel pumps (push to arm)
3. ) Bleeds/packs

Question 3

After start FO flow

Answer 3

1.) Bleeds/packs
2.) Anti-ice (as required)
3.) Probes (heated)
4.) Thrust reversers (arm)
5.) Transponder (set)
—————————————————————-
6.) Flaps (set)
7.) Flight controls (check, except rudder as the captain does that)

Question 4

Before takeoff to the line FO flow

Answer 4

1.) Flight attendants (make a PA to let them know were getting ready to depart)

Question 5

Before takeoff below the line FO flow

Answer 5

1.) Fuel crossflow (manual mode, to inhibit auto cross flow on TO)

Question 6

After takeoff PM flow

Answer 6

1. ) Thrust
2. ) Fuel crossflow (turn off manual mode)
3. ) Thrust reversers (off)
4. ) Sterile cockpit

Question 7

In range PM checklist

Answer 7

1. ) Flight attendants (let them know were preparing for landing)
2. ) Pressurization (make sure landing elevation is set)
3. ) Landing data
   - V-speeds input
   - Approach set in FMS
   - Correct frequencies set on both pilots sides, but no in active, only in standby

Question 8

In range PF flow

Answer 8

1.) Briefings (arrival and approach)

Question 9

Before landing PM flow

Answer 9

1.) Thrust reversers (armed, after flaps 45)

Question 10

After landing FO flow

Answer 10

1. ) Anti-ice (as required)
2. ) Probes (as required)
3. ) Flaps (up)
4. ) Radar (off)
5. ) Transponder (as required)

Question 11

Shutdown FO flow

Answer 11

1. ) Anti-ice (off)
2. ) Fuel pumps (de-arm)
3. ) Transponder (set to standby?)