What is the purpose of Incore NIs (Movable Incore Detection System (MIDS))?
- Maps radial / axial flux distribution to confirm core design parameters
- Determines magnitude / location of fuel burnup
- Identify misaligned rod***
- Perform flux profiles / QPTRs
What is the speed of the MIDS Drive Units in SLOW speed?
- 12ft/min while scanning core ***
What is the speed of the MIDS Drive Units in FAST speed?
- 72 ft/min from withdrawn to bottom of core ***
What does the Withdraw Limit Switch do?
- Stops automatic MIDS withdrawal
and - prevents operation of the 5 or 10 path rotary device unless the detector is in the withdrawn position
- Deenergizes drive motor
What does the Safety Limit Switch do?
- Stops automatic MIDS withdrawal if the withdraw limit switch fails ***
- Deenergizes drive motor
What is the purpose of the guide tubes?
- Provide support and structure for the guide thimbles and are an integral part of the RCS Pressure Boundary
What is the purpose of the Guide Thimbles?
- Guide thimbles are located inside guide tubes
- 58 stainless steel incore flux thimbles that insert into fuel assemblies and are retracted during refueling
What are the seal table valves for?
- Designed to close without cable through but has the ability to cut cable for emergency isolation.
- Prevent RCS leakage in case of thimble tube rupture
What does the leak detection system for the Incore NIs do?
- All 10 path devices have a common drain and if there is a leak, it alarms in CR ***
- Monitors ten path transfer devices for thimble tube leaks
- Pressure switch provides an alarm to the control room for sufficiently sized leak in a thimble tube
- Pressure switch also opens drain solenoid valve and directs water to the sump
- When level decreases the alarm will extinguish and drain valve will close
Where does the Five Path common group align to?
- C 10-Path transfer device
What do the CETCs do?
- Measures, processes, and displays reactor core outlet temperatures.
- Provides fuel assembly outlet temperatures at selected core locations to monitor core performance during operational and emergency conditions and during half-loop operations.
How many CETCs are rated at 200°F - 2300°F?
- 63 CETCs
How many CETCs are rated at 200°F - 500°F for mid loop monitoring?
- 2 CETCs
What powers the Train A CETCs?
- CRID 1
What powers the Train B CETCs?
- CRID 4
How many core locations are available for MIDs?
- 58
CETC wiring pass thru RV Head penetrations, how many do they use?
- 5
On the 5 path device, where does the detector go when selected to Emergency?
- Next 10 Path
What two dissimilar metals do the CETCs use?
- Chromel and Alumel
How do we frequently verify Hot Channel Factors during normal ops?
- AFD, QPTR, Rod Insertion Limit
CETCs have an input to which CR indications?
- SMM, PPC, MLM, and Recorders
