GENERAL LIMITATIONS.
For wingspan-limited taxi operations, the Aircraft Design Group identifiers are:
Group III (FAA) Code C (ICAO)
GENERAL LIMITATIONS.
The 737 is certified for extended operations up to how many minutes (ETOPS)?
180 minutes ETOPS.
GENERAL LIMITATIONS.
What approach Category is the 737?
Circling:
All are CAT D
GENERAL LIMITATIONS.
Flight maneuvering load acceleration limits:
FLAPS UP
+ 2.5g to -1.0g
GENERAL LIMITATIONS.
Flight maneuvering load acceleration limits:
Flaps Down
+2.0g to 0.0g
(MAX) with flaps 30 and 40, positive limits vary linearly from +2gs at max landing weight to +1.5g at maximum takeoff weight.
Memory Limitation.
OPERATING LIMITATIONS.
* Maximum Operating Pressure Altitude?
* 41,000 feet.
OPERATING LIMITATIONS.
Maximum Takeoff/Landing Pressure Altitude.
10,000 feet.
OPERATING LIMITATIONS.
Maximum Runway Slope.
+/- 2%
OPERATING LIMITATIONS
Normal runway width.
148 feet wide or greater (a narrow runway is less than 148’ in usable width, but not less than min runway width.
In winter with partially cleared runways, the full width of the runway is considered usable when the contamination depth outside the cleared portion is 6 inches or less.
OPERATING LIMITATIONS.
Minimum runway width.
100 feet.
any operations on runways narrower than the mins must be approved by the managing director of Flt ops (see FOM)
In winter with partially cleared runways, the full width of the runway is considered usable when the contamination depth outside the cleared portion is 6 inches or less.
OPERATING LIMITATIONS.
Requirements to TAKEOFF from narrow runways.
OPERATING LIMITATIONS.
Requirements for LANDING on narrow runways.
OPERATING LIMITATIONS.
** Maximum takeoff / landing tailwind component.
** 15 knots.
VMO / MMO
VMO: upper barber pole on speed tape
MMO: .82M
Maximum gear RETRACTION speed.
235 kts
Maximum gear EXTENSION speed.
270 / .82M
Maximum gear OPERATING/EXTENDED speed.
320 / .82M
** TURB N1 SETTING FROM CRUISE PAGE
MEMORY ITEM
** Recommended severe turbulence penetration speed for CLIMB & DESCENT.
** 280 kts / .76M
If severe turbulence is encountered at altitudes BELOW 15,000’ and if the airplanes gross weight is LESS THAN the MAX LDG WT (what speed can you go)?
Aircraft can be slowed to 250 kts in the CLEAN configuration.
What is the minimum ground time after landing if the landing weight exceeds the value in the Max Quick Turn Around Weight Limits table? [Steel Brakes / Carbon Brakes]
Steel: 67 Minutes
Carbon: 48 Minutes.
MEMORY ITEM
** Takeoff crosswind component (knots) Blended Winglet/Split Scimitar Winglet with a runway condition code of 6 (Surface condition - Dry (smooth, grooved or PFC)?
** 34 /33 (assumes an engine failure RTO)
MEMORY ITEM
** LANDING crosswind component (knots) Blended Winglet/Split Scimitar Winglet with a runway condition code of 6 (Surface condition - Dry (smooth, grooved or PFC)?
** 40 / 37 kts.
MEMORY ITEM
** TAKEOFF crosswind component (knots) Blended Winglet/Split Scimitar Winglet with a runway condition code of 5 (Braking action Good - SFC condition for smooth, grooved or PFC is Wet / Damp (visible moisture), Frost or 1/8” or less of: Water, Slush, Dry or Wet Snow.)
25 /25 (assumes an engine failure RTO)