Memory Items

Question 1

Aborted engine start L, R

Answer 1

1. Fuel Control switch - Cutoff

Question 2

Airspeed Unreliable

Answer 2

1. Autopilot disconnect switch - push
2. A/T Arm switches (both) - Off
3. F/D switches (both) - Off
4. Set gear up pitch attitude and thrust:
   Flaps extended - 10 deg. 85% N1
   Flaps up - 4 deg. 70% N1

Question 3

Cabin Altitude

Answer 3

1. Don O2 masks
2. Establish crew communications
3. Check cabin altitude and rate
4. IF cabin altitude uncontrollable:
   PASS O2 switch - Push to ON and hold for 1 second
   WITHOUT DELAY, descend to the lowest safe altitude or 10,000 ft, whichever is higher.

To descend: move thrust to idle
- extend speedbrakes
- if structural integrity is in doubt, limit airspeed and high maneuvering loads
- descend at Vmo/ Mmo

Question 4

Dual engine fail/stall

Answer 4

1. Fuel Control switches (both) - Cutoff, then Run
2. Ram Air Turbine switch - Push and hold for 1 second

Question 5

Eng Autostart L, R

Answer 5

1. Fuel Control switch (affected side) - Cutoff

Question 6

Engine Limit Exceed L, R

Answer 6

1. A/T Arm switch (affected side) -
   Confirm - Off
2. Thrust lever (affected side) - Confirm - Retard until Eng Limit Exceed message blanks or lever is at idle

Question 7

Engine Surge L, R

Answer 7

1. A/T Arm switch (affected side) - Confirm - Off
2. Thrust lever (affected side) - Confirm-Retard until Engine Surge message blanks or thrust lever is at idle

Question 8

Engine Severe Damage / Sep L, R
condition: one or more of these occur:
- airframe vibrations w abnormal engine indications
- engine separation

Answer 8

1. A/T Arm switch (affected side) - Confirm - Off
2. Thrust lever (affected side) - Confirm - Off
3. Fuel Control switch (affected side) - Confirm - Cutoff
4. Engine Fire switch (affected side) - Confirm - Pull

Question 9

Fire Eng L, R
- In Flight

Answer 9

2. A/T Arm switch (affected side)
   - Confirm - Off
3. Thrust lever (affected side) - Confirm
   - Idle
4. Fuel Control switch (affected side)
   - Confirm - Cutoff
5. Engine Fire switch (affected side)
   - Confirm - Pull
6. IF the Fire Eng message stays shown:
   Engine fire switch - rotate to the stop and hold for 1 second

Question 10

Stabilizer
Condition : One of these occurs:
- Stabilizer movement w/o a signal to trim
- Stabilizer is failed

Answer 10

1. Stab cutout switches (both) - Cutout
2. Do not exceed current airspeed