Flows

Question 1

Preliminary Pre-Flight (17)

Answer 1

1. IRS Mode Selectors - OFF, then NAV
2. Voice Recorder Switch - ON
3. Verify
   -Oxygen Pressure
   - Hydraulic Quantity
   -Engine Oil Quantity
   Check the maintenance documents and aircraft logbook.
4. Flight Deck Access System Switch - GUARD CLOSED
5. Emergency Equipment - CHECK
6. ELT Switch - GUARD CLOSED
7. PSEU Light - EXTINGUISHED
8. GPS Light - EXTINGUISHED
9. Service Interphone - OFF
10. Engine Panel - SET
11. Oxygen Panel - Set
12. Landing Gear Indicator Lights - ILLUMINATED
13. Flight Recorder Switch - GUARD CLOSED
14. Mach Airspeed Warning Test Switches - PUSH TO TEST
15. Stall Warning Test Switches - PUSH TO TEST
16. Check the following:
    - Circuit Breakers - none popped
    - Manual Gear Extension Door Closed
17. Parking Brake - SET

Question 2

Before Start (8)

Answer 2

1. CDU Display - Set
2. N1 Bugs - Check
3. IAS Bugs - Set
4. Exterior Doors - Closed
5. Windows - Closed/Locked
6. Fuel Pumps - Set
7. Hydraulic Pumps - Set
   - Bypass Pin = A&B ON
   - No Pin - B ONLY
8. Anti Collision Light - ON
   If at night WING INSP. light ON too.

Question 3

Pushback or Towing Procedure (2)

Answer 3

1. Transponder Mode Select - SET
   - Select ALT ON/XPNDR
   - Select ATC 1 or 2

When pushback complete, tow-bar disconnected, and nose gear steering lockout pin is removed:

2. System A HYD Pumps - ON
   - Low Press. Lights extinguished
   - System A pressure minimum of 2800 psi

Question 4

Engine Start Procedure (4)

Answer 4

1. Select Secondary Engine Indications
2. PACK Switches - OFF
3. Engine Start Switch - GRND
4. Monitor Engine Start

Prior to starter cutout -
Monitor fuel flow & EGT

After Starter Cutout -
Call “Starter cutout”
Monitor N1 ,N2, EGT, FF, & Oil pressure

At 56% N2 if engine start switch doesn’t return automatically to AUTO/OFF move it to AUTO/OFF

Start Valve Open alert extinguishes

Question 5

Before Taxi (13)

Answer 5

1. Generator Switches - ON
2. Probe Heat - ON
3. Engine/Wing Anti-Ice - AS NEEDED
4. PACK Switches - AUTO
5. Isolation Valve - AUTO
6. APU Bleed - OFF
7. APU Switch - AS NEEDED
   - Allow 1 minute with bleed off prior to APU shut down
8. Missing
9. Ground Equipment - CLEAR
10. Flaps - SET
    - set flaps after captain cals “flaps ____”
11. Lower DU - BLANK
12. Transponder - ALT ON/XPNDR
13. Recall - CHECK

Question 6

Before Takeoff (3)

Answer 6

1. Weather/Terrain - AS NEEDED
2. Exterior Lights - ON
   All but landing lights on before cleared T/O
   All lights on including landing when cleared
3. Transponder - TA/RA

Question 7

After Takeoff (5)

Answer 7

1. Engine Bleeds - OPERATING
2. PACKS - OPERATING
3. Engine Start Switches - AUTO/OFF
4. Autobrake - OFF
5. Landing Gear Lever - OFF
   - After landing gear retraction is complete.

Question 8

Descent (8)

Answer 8

1. RNP - Verify
2. Center Tank Fuel Pumps - SET
   - See FCOM
3. Pressurization - Verify Set to Destination
4. Recall - REVIEW
5. Vref on APP Ref Page - ENTER
6. RADIO/BARO minimums - SET
7. Radios/Courses - SET FOR APPROACH
8. Check the landing performance and set auto-brake to the desired setting.

Question 9

After Landing (8)

Answer 9

1. APU - START (AS NEEDED)
2. Probe Heat - AUTO/OFF
3. Exterior Lights - SET
4. Engine Start Switches - AUTO/OFF
5. Autobrake - OFF
6. Flap Lever - UP
7. Transponder - ALT ON/XPNDR
8. Weather Radar - OFF

Question 10

Shutdown (16)

Answer 10

1. Electrical Power - SET
2. Fasten Belts - OFF
3. Anti-Collision - OFF
4. Fuel Pumps - OFF
5. CAB/UTIL Power Switch - OFF
6. Wing/Engine Anti-Ice - OFF
7. Hydraulic Panel - SET
8. PACKS - SET
9. Isolation Valve Switch - OPEN.
10. Engine Bleed Witches - ON
11. APU Bleed Switch - ON
12. Exterior Light Switches - AS NEEDED
13. Flight Director Switches - OFF
14. Transponder Mode Selector - STBY
15. APU Switch - AS NEEDED
    - Run the APU for one minute with no bleed air load before shutdown
16. Flight deck Door - UNLOCK

Question 11

Secure (4)

Answer 11

1. IRS Mode Selectors - OFF
2. Emergency Exit Light Switch - OFF
3. Window Heat Switches - OFF
4. PACK Switches - OFF